4
4.1
Setting:
Stitch
width
control
Zeroing
the
needle
for
straight
stitching
When
the
stitch
width
control
is
set
at
"0"
the
needle
bar
must
not
move
to
the
side.
4.0.1
Adjustment:
4.1.1
Set
needle position lever 1 at its central position.
.2
Loosen
screws
2
and
3.
.3 Loosen clamp screw 4 and let lockinglever5 move back
until
its spring is relaxed.
.4 In this position, tighten
clamp
screw
4.
.5 Move stitch width lever 6 to the right
as
far
as
it
will
go (i.e. towards "0").
.6 Turn on the master switch and let the machine run slowly. Move
stitch
width lever 6 to
the
left until
the
needle
bar
stops
swinging
sideways.
.7 Inthis position push screw 2 to the right
as
far
as
it
will
go and tighten it.
.8 Check this adjustment (see "Setting").
.9
Switch
off
master
switch.
.
10
Screw
3
is
still
loose.
8
From the library of Superior Sewing Machine & Supply LLC - www.supsew.com
To Next Page
Loading...
Need help?
General
