Sewing
30
8.03 Malfunctions
8
.03.01 Error messages
When an error occurs, an error code appears on the display together with short instructions.
An error message is caused by incorrect settings, defective elements or seam programs as
well as by overload conditions. See Chapter 8.03.02 Description of the error messages for a
description of the error codes.
Eliminate error. ●
Acknowledge error elimination by pressing the "TE/speed" key. ●
8.03.02 Description of the error messages
Error
code
Cause Remedy
E001 Pedal not in rest position when
machine is switched on
Check pedal
E009 Start inhibitor at standstill Bring sewing head to its basic positi-
on
E010 Machine class altered Switch control unit off, then on again.
E062 Voltage of power supply unit (24 V)
too low
Check connected consumers
E063 Power supply unit (24 V) overloaded Check connected consumers
E064 "Mains off" signal when machine is
switched on
Contact service
E065 IGBT error when machine is swit-
ched on
Contact service
E066 IGBT test with error recognition Contact service
E067 Mains off Switch on mains
E068 Overcurrent motor during operation Contact service
E009
PRESS TE-SPEED
To Next Page
Loading...