Revision 3 | Granolyser / Granolyser HL operating instructions
Danger area
The entire area one meter around the
GRANOLYSER is a danger area during maintenance and repair work.
Keep the area around the
GRANOLYSER clear of objects.
2.5 Operating and maintenance personnel
Operating and maintenance personnel are people who are responsible for transport, installation, setup,
operation and cleaning of the
GRANOLYSER, and for eliminating malfunctions.
1. The
GRANOLYSER is only allowed to be operated by authorized and instructed people.
2. The responsibilities for operating the
GRANOLYSER must be clearly defined and complied with so that
no unclear competencies arise with regard to the aspect of safety.
3. The switch-off procedure specified in the operating instructions must be complied with during all work
(operation, maintenance, repair, etc.), see chapter 2.10.
4. The operator must refrain from any working method that impairs safety on the
GRANOLYSER.
5. The operator must ensure that only authorized people work on the
GRANOLYSER.
6. The operator is obliged to report immediately to the owner any changes that take place on the
GRANOLYSER which impair safety.
7. The operating personnel must be provided by the owner with appropriate protective equipment in
accordance with legal requirements and the material to be processed.
8. The owner must issue regular instructions regarding the use of personal protective equipment, and
must check that such equipment is being used.
2.6 Safety measures (to be carried out by the owner)
It should be noted that the owner is responsible for the following aspects with regard to the operating
and maintenance personnel
Providing instruction in the protective instruments for the
GRANOLYSER
Monitoring compliance with the safety measures
The frequency of the function tests described in chapter 8.3 must be complied with.
The work described in these operating instructions is configured in such a way that
it is explained in the chapters Function and Operation for the operating personnel
it is explained in the chapters Delivery, Transport and storage, Installation and commissioning,
Maintenance and cleaning, Malfunctions – causes and rectification and Dismantling and disposal for
a specialist operator.
The chapters Delivery, Transport and storage, Installation and commissioning, Maintenance and cleaning,
Malfunctions – causes and rectification and Dismantling and disposal are only intended for specialist
operators. Work described in this chapter is only to be carried out by specialist operators.
Instructed person
A person who has been instructed and, if necessary, trained by a specialist operator regarding the tasks
assigned to him/her and the possible dangers in the event of incorrect conduct, and who has also been
instructed regarding the necessary protective instruments and protective measures.
Specialist operator
An individual who, due to his/her relevant specialist training and/or experience, is capable of recognizing
risks and avoiding dangers that may occur during use of the product.
(Definition according to DIN EN 82079-1:2013-06)
To Next Page
Loading...
Need help?
General
