Installation and commissioning
Revision 3 | Granolyser / Granolyser HL operating instructions
5 Installation and commissioning
The Installation and commissioning chapter is only intended for specialist operators.
Installation
Carefully unpack the
GRANOLYSER (see chapter 4.4).
Place it horizontally on a solid table with a smooth, clean surface.
Ensure that a firm footing on a non-slip surface is provided.
The table must be protected against shocks.
Do not place any vibrating instruments, such as sorting machines or shaking apparatus on the same
table.
Make sure there is an adequate distance to all sides so that no heat buildup can occur.
Avoid exposure to direct sunlight and extreme ambient conditions.
Make sure that the installation height is ergonomic according to the stature of the operating
personnel.
Installation in unheated, draughty and dusty surroundings can have a negative effect on
the service life of the GRANOLYSER.
Connect the supplied mains cable with removable connection (power connector cable IEC 60320 C13)
to the
GRANOLYSER.
Ensure that the mains cable is never a tripping hazard or that someone can become caught or step
on it.
Connect the plug of the mains cable to a suitably earthed socked with protective
earth conductor.
Switch on the
GRANOLYSER via the main switch position I (ON).
Observe the information on operation in chapter 7.
To Next Page
Loading...
Need help?
General
