Revision 3 | Granolyser / Granolyser HL operating instructions
7.7.3 User selection
A change of user is required to make
certain settings.
The Expert and Service
password protected.
The measurements can be assigned
to a specific person by selecting an
individually created user name.
Select user name and enter
password.
An empty user name is set by default (i.e. a blank line), without a password.
Log in
Log out
Whenever the GRANOLYSER is switched on (restarted), no user name is selected. Following a change of
user, the user is personally responsible for canceling the "User name" selection again (logging out) or
selecting a new user name. If you would like to actively log out your own user name without logging in
under another user name at the same time, select the empty user name without a password. The user
name is not associated with an authorization.
The user name is stored with the measurement results and printed.
Define user names and passwords, see expert instructions.
7.7.4 Print options
with/without logo
with/without text
automatically
After each measurement, the
measurement result is
automatically printed out.
Generates the print preview on
the right-hand side.
Test printout
(without measurement results)
Insert another logo and change text, see expert instructions.
To Next Page
Loading...
Need help?
General
