AxN Configurable Motion Control Platform
10
» Do not touch housing surfaces of motors! Danger of burns!
» According to operating conditions, temperatures can be higher than 60 °C, 140 °F during or
after operation.
» Before accessing motors after having switched them off, let them cool down for a sufficiently
long time. Cooling down can require up to 140 minutes! Roughly estimated, the time required
for cooling down is five times the thermal time constant specified in the Technical Data.
» After switching drive controllers or chokes off, wait 15 minutes to allow them to cool down
before touching them.
» Wear safety gloves or do not work at hot surfaces.
» For certain applications, the manufacturer of the end product, machine or installation,
according to the respective safety regulations, has to take measures to avoid injuries caused
by burns in the end application. These measures can be, for example: warnings, guards
(shielding or barrier), and technical documentation.
Protection during Handling and Mounting
In unfavorable conditions, handling and assembling certain parts and components in an improper
way can cause injuries.
Risk of injury by improper handling! Bodily injury by bruising, shearing, cutting,
hitting!
» Observe the general construction and safety regulations on handling and assembly.
» Use suitable devices for assembly and transport.
» Avoid jamming and bruising by appropriate measures.
» Always use suitable tools. Use special tools if specified.
» Use lifting equipment and tools in the correct manner.
» If necessary, use suitable protective equipment (for example safety goggles, safety shoes,
safety gloves).
» Do not stand under hanging loads.
» Immediately clean up any spilled liquids because of the danger of skidding.
To Next Page
Loading...