133
Flash Lead Connection
A ash cable is always connected to the Hasselblad H1/H2 camera body.
The ash sync cable must not be connected to the camera back when used on
a Hasselblad H1/H2. The ash sync connector on the IQ back is only intended
for use with a Phase One FlexAdaptor or other large format adaptors.
16.4 Cables Shipped with IQ back for Hasselblad H
No cables are required to use the IQ back with a Hasselblad H1/H2.
A Value Added IQ back comes with an additional multi connector to Lens
sync cable (part# 50300143) for use with large format cameras in two shot
mode.
Part# 50300144 This cable is available as a seperate purchase only.
From multi connector to mini jack female (for use to adapt older Large
format wakeup cables or older Kapture Group one shot adaptor cables to
connect to the multiport).
To Next Page
Loading...
