50
TROUBLESHOOTING
No Power
• Check the TV power cord. Unplug the TV, wait 10 seconds,
then reinsert the plug into the outlet and push the POWER
button again.
• Check that the outlet is not on a wall switch.
• Be sure the fuse is not blown on the AC power strip, if one is
being used.
No Picture
• Check antenna connections. Are they properly secured to the
TV's ANT 75Ω plug?
• Check the TUNER MODE control for the correct tuner set-
ting.
•Try running the Auto Program feature to find all available
channels.
No Sound
• Check the VOLUME buttons.
• Check the MUTE button on the remote control.
• Check the SPEAKER on-screen control. If it is in the OFF
position, sound at the set will be eliminated.
• If you’re attempting to hook up auxiliary equipment, check
the audio jack connections.
• (If applicable) Check the audio receiver for the correct operat-
ing mode.
Remote Does Not Work
• Check the batteries. If necessary, replace them with AA
Heavy Duty (Zinc Chloride) or Alkaline batteries.
• Clean the remote control and the remote control sensor win-
dow on the TV.
• Check the TV power cord. Unplug the TV, wait 10 seconds,
then reinsert the plug into the outlet and push the POWER
button again.
• Be sure the fuse is not blown on the AC power strip, if one is
being used.
• Check to be sure the TV outlet is not on a wall switch.
TV Displays Wrong Channel or No
Channels Above 13
• Repeat channel selection.
• Add the desired channel numbers (using the CHANNEL
EDIT control) into the TV’s memory.
• Check to be sure the TUNER MODES are set to the CABLE
option and run the Auto Program feature to find all available
channels.
Cleaning and Care
•To avoid possible shock hazard, be sure the TV is unplugged
from the electrical outlet before cleaning.
• When you are cleaning the TV, take care not to scratch or
damage the screen surface (avoid wearing jewelry or using
anything abrasive). Wipe the front screen with a clean cloth
dampened with water. Use even, easy, vertical strokes when
cleaning.
• Gently wipe the cabinet surfaces with a clean cloth or sponge
dampened in a solution of cool, clear water. Use a clean, dry
cloth to dry the wiped surfaces.
• Never use thinners, insecticide sprays, or other chemicals on
or near the cabinet, as they might cause permanent marring of
the cabinet finish.
To Next Page
Loading...
