Philips DVT1300 - Repeat or Loop a Sequence; Index Marks; Adding Index Marks; Switching to Index Marks

25
Playback
Table of contents
6.5.2 Repeat or loop a sequence
1
During playback, press the menu key ` to specify the sequence start
point.
X The symbol Ãis shown on the display.
2
Press the menu key ` again to specify the sequence end point.
X The repeat sequence begins.
3
Press the menu key ` to end repeating of the sequence and resume
normal playback.
6.6 Index marks
Index marks can be used to mark certain points in a recording as points of
reference.
6.6.1 Adding index marks
1
In playback mode, press the INDEX key to add an index mark.
X
INDEX and the index mark number appears briefly on the display.
Up to 10 index marks can be added per file.
Index full will be displayed
if 10 index marks were set.
Tip
• You can also set index marks while the playback is paused.
6.6.2 Switching to index marks
1
In playback mode, press the INDEX key for approximately one second.
2
Press h / b to select Go to index.
3
Press the record key g to confirm.
X A list of all index marks is displayed.
4
Press h / b to select the desired index mark.
5
Press the record key g to confirm.
6.6.3 Deleting an index mark
1
In playback mode, press the INDEX key for approximately one second.
2
Press h / b to select Delete index
3
Press the record key g to confirm.
X A list of all index marks is displayed.
4
Press h / b to select the desired index mark.
5
Press the record key g to confirm.