Philips DVT1300 - Device Reset

37
Service
Table of contents
9.1.3 Device reset
This function is used to return all settings to the factory defaults. Recordings
and files are not deleted.
1
In stop mode (start screen), press the menu key `.
2
Press h / b to select the device settings menu ×.
3
Press the record key g to confirm.
4
Press h / b to select Reset settings.
5
Press the record key g to confirm.
6
Press h / b to select OK.
7
Press the record key g to confirm.
X All device settings will be reset to the factory defaults. You must
reset the display language, date and time (see also chapter 4.3 Initial
installation process, page 15).
9.2 Replacing batteries or rechargeable batteries
Caution
• Do not remove batteries or rechargeable batteries from the device
while it is recording. If you do this, data may become damaged or lost.
Device malfunctions may also occur.
When the batteries are nearly empty, the battery indicator flashes; replace
them as soon as possible.
Proceed as described in 4.1 Inserting the batteries.
Note
• If it takes longer than 2 minutes to replace the batteries, you may have
to reset the time.
• Never try to recharge alkaline or non-rechargeable batteries.
• Batteries and rechargeable batteries contain substances that may
pollute the environment. Used batteries and rechargeable batteries
should be disposed of at an ocial collection point.