Philips ErgoLine D320 - Page 44

ErgoLine D330/D340
Customer Engineer Manual
Page 2-24
F
OOTPEDAL
(
FUNCTION CODE
111)
Can only be switched on and off when the terminal is idle.
Function can be activated via the toggle list or through a function code.
S
ECOND
R
INGER
(
FUNCTION CODE
112)
Can only be switched on and off when the terminal is idle.
Function can be activated via the toggle list or through a function code.
B
USY
I
NDICATION
(
FUNCTION CODE
113)
Can only be switched on and off when the terminal is idle.
Function can be activated via the toggle list or through a function code.
M
ANUAL BUSY
I
NDICATION
(
FUNCTION CODE
114)
Can only be switched on and off when the terminal is idle.
Function can be activated via the toggle list or through a function code.
D
OOR
O
PENER
(
FUNCTION CODE
115)
Function can be only be activated via a function code.
X-
INPUT INSTEAD OF
M
ICROPHONE
(
FUNCTION CODE
116)
Digital equipment which support the X-protocol can be enabled/disabled
in the idle and busy condition. This can be done via the toggle list or via a
function code.
H
ANDSET WITHOUT
H
OOKSWITCH
(
FUNCTION CODE
117)
Allows the use of the handset with the hookswitch disabled. A function key
with ‘hookswitch’ functionality has to be programmed, or a ‘footpedal’ has
to be connected to allow correct operation of the function.
Can be activated via the menu or via a function key. The operation mode
will be displayed when the terminal is idle.
H
EADSET
(
FUNCTION CODE
118)
The hookswitch is disabled when this operation mode is active. A function
key with ‘hookswitch’ functionality has to be programmed, or a ‘footpedal’
has to be connected to allow correct operation of the function.
Can be activated via the menu or via a function key. The operation mode
will be displayed when the terminal is idle.
K
EYCLICK
Y
ES
/N
O
(
NO FUNCTION CODE
)
The Keyclick is only available for the ASCII keyboard. The function is only
available via the menu.
Default setting is
keyclick off
(no).