A Quick Description of the Measurement Server
8
Introduction to the Instrument
M3001A Connectors and Keys
1 White ECG/Resp connector. 6
NBP Start/Stop key - starts or stops NBP
measurements.
2 Blue SpO
2
connector 7
Either:
NBP STAT key - starts NBP STAT series of
measurements.
or
Zero key -
initiates a zero procedure for the
connected pressure transducer when pressed and held
for a second.
3 Red NBP connector 8 Alarm Silence/Reset
4 &
5
Combined pressure (red) and temperature (brown)
connector - connect either invasive pressure
transducer or temperature probe (M3000A #C06;
M3001A #C06 and #C18 only).
Press and temp cannot be used at the same time.
You might have a version of the Measurement Server
that does not have this connector.
9
MSL cable connector to the monitor.
To Next Page
Loading...
