Philips M3046A - With the Measurement Server Separate from the Monitor

Connecting the Measurement Server...
Installin
g
the Instrument 73
...with the Measurement Server Separate from the Monitor
You can connect the Measurement Server to the Monitor using a server link cable (MSL) as
follows:
Step 1 You can connect the cable to the plug on the link bar, or directly to the Monitor as
follows:
To remove the link bar,
a.Turn the latch guard away from the edge of the latch.
b.Unlatch the link bar from the back of the Monitor.
c.Slide the link bar away from the Monitor.
Step 2 Attach the socket end of the cable to the Monitor.
Step 3 Attach the other end of the cable to the Measurement Server or, if present, the
M3015A/M3016A Measurement Server Extension.
Link Bar
Latch