Disassembly for the Monitor
226 Re
airin
the Instrument
Step 8 Withdraw the board from the chassis towards and slightly to the right of you to
avoid hitting the chassis:
Removing the Wireless Assembly (for Monitors with Wireless
LAN Interface only)
Step 1 Remove the Server as described previously in this chapter.
Step 2 Remove the battery as described previously in this chapter.
Step 3 Remove the chassis as described previously in this chapter.
Step 4 Remove the system board, complete with the wireless LAN assembly, as described
previously in this chapter.
Step 5 Lift the wireless assembly up to release the connector, then remove the assembly
from the system board.
Removing the LCD Assembly and Backlight Tubes
This procedure describes how to remove the LCD Assembly which includes the LCD screen
and rubber anti-vibration cushion. Once the assembly has been removed, the backlight tubes
can be removed and replaced.
Although you need to remove the chassis, you do not need to remove the System Board or the
Power Supply.
To remove the LCD Assembly, do the following:
Step 1 Remove the chassis as described previously in this chapter.
Step 2 Use a small screwdriver to remove the Display Assembly cable.
Step 3 Push the complete assembly (including the rubber cushion, the LCD display, and
the cables) out from the rear of the chassis. Start pushing from the top being careful
not to damage or bend the 6 clips around the cushion:
To Next Page
Loading...
