Philips M3046A - Removing the System Board

Disassembly for the Monitor
224 Re
p
airin
g
the Instrument
Step 11 Remove the four screws from the rear panel:
Step 12 Slide the chassis slowly out from the front of the housing (the battery compartment
cover must be open), and lay the chassis on the Monitor Bezel
For Monitors with a Wireless LAN Assembly: To avoid antenna damage, slide
the chassis very carefully out from the front of the housing, disconnect the antenna
cable and lay the chassis on the Monitor Bezel:
Removing the System Board
To remove the System Board, do the following:
Step 1 Remove the Power Supply as described previously in this chapter.
Step 2 Remove the chassis as described previously in this chapter.
1