PAGE 4-6
1097626, V
ER. 03
4.4 SIMPLYGO DEVICE PULSE MODE WARM-UP BREATHING
When you turn on your SimplyGo device, it will sense if you are breathing from it. If you are not yet breathing
through the cannula, SimplyGo will begin to pulse automatically about once every five seconds. The only
purpose of this “device warm-up breathing” is to help the device warm up faster. As soon as you begin
breathing through the cannula, the device will begin delivering pulses based on your breathing. Device warm-
up breathing occurs only when your first turn on the device. You may begin breathing from the SimplyGo at any
time. If the device does not sense a breath after two minutes, a No Breath alarm will sound.
4.5 SIMPLYGO INSERTION AND REMOVAL OF THE BATTERIES
To insert the battery correctly, follow these steps.
1. Place your device in a well ventilated location and make sure it is turned off.
2. To remove the battery, insert your fingers into the opening in the battery handle. Steadily pull
upward on the handle until the battery is released from the enclosure. Continue to lift the battery
until it is entirely removed from the battery compartment. If the device has been operating, the sur-
faces may be warm to the touch. This is normal.
3. Check the battery gauge. To do so, press the white button on the battery and watch how many
LEDs light up. If the batteries are low, you can recharge them.
4. To insert the battery, insert your fingers into the opening in the battery handle and grip the handle
between your fingers and thumb. Position the battery over the battery compartment in the top,
rear corner of the SimplyGo enclosure with your fingers pointing toward the handle. The battery
compartment is shaped so that there is only one way the battery can be inserted and this will align
the battery correctly. Lower the battery into its compartment until the handle contacts the equip-
ment enclosure. Firmly push on the battery handle until it snaps into place in the enclosure top.
5. After the battery is inserted, check to make sure the battery handle is level with or slightly below
the top of the plastic case.
6. Momentarily depress the Power key, and the following should occur.
• The LCD and the 5 Key backlights turn ON
CAUTION
Only remove the battery when the SimplyGo is turned off.
Never remove the battery while the device is operating.
No. of LEDs Battery Charge
4 LEDs Light: 75% to 100% full
3 LEDs Light: 50% to 75% full
2 LEDs Light: 25% to 50% full
1 LED Light: 10% to 25% full
1 LED Blinks 3 Times: Battery is less than 10% full and needs to be recharged.
To Next Page
Loading...
