PAGE 7-28
1097626, V
ER. 03
7.15 COMPRESSOR REPLACEMENT
Removal:
1. Remove the Rear Enclosure.
2. Remove the Front Enclosure.
3. Remove both of the Sieve Canisters.
4. Remove the Compressor Cover.
NOTE
For SimplyGo, if replacing a Moog compressor with a Shinano compressor, ensure to perform the
Compressor Upgrade Programming Procedure after installation procedure. (page 7-32)
The Moog brand motor can be seen through the device’s fan as shown below.
To Next Page
Loading...
