PAGE 4-71097626, VER. 03
• The screen shown here displays on the LCD
4.6 OPERATING THE DEVICE AND CHANGING DEVICE SETTINGS
4.6.1 OPERATING THE SIMPLYGO DEVICE AND CHANGING DEVICE SETTINGS
You can change all device settings using the buttons on the control panel. This includes starting the device,
stopping it, silencing an alarm, and changing oxygen flow.
To start your SimplyGo device, follow these steps.
1. Connect a nasal cannula to the patient cannula connector on the top of the device. Ensure the
cannula is routed to prevent it from being pinched or kinked to avoid a disruption.
2. To start the device, press the Power button. After the first press, the display screen and the 5 but-
ton backlights turn off and on and you will see a screen similar to the one below, left. If the battery
capacity is 1/2 full and the battery is being charged, the screen will appear as shown right.
NOTE
If you do not see the battery symbol or the device does not turn
On, the battery is not installed correctly. Re-insert the battery
and make sure it snaps in place.
NOTE
A standard single lumen nasal cannula and tubing should be
used to deliver oxygen from the SimplyGo device. The device
works with cannula tubing up to 30 ft. (9m).
To Next Page
Loading...
