PAGE 4-111097626, VER. 03
11. When you are ready to turn your SimplyFlo device off, press the Power button. The screen below
appears.
12. Press the Power button a second time and the SimplyFlo device will turn off.
13. Rather than pressing the Power button a second time, when this screen is displayed, the back light
intensity may be increased or decreased by repeatedly pressing the Plus (+) or Minus (-) key until
the desired back light intensity is achieved.The device may then be powered off using steps 11
and 12 above.
4.7 CLEANING THE SIMPLYGO/SIMPLYFLO AND SIMPLYGO RECHARGEABLE BAT-
TERY
The exterior covers of the device and rechargeable battery should be cleaned as needed:
1. Turn the device off and disconnect from the power source before cleaning.
2. If the SimplyGo battery is removed, wipe the battery bay and battery with a dry cloth.
3. Clean the device exterior using a damp cloth with a mild household cleaner and wipe dry. Or, if you
use medical disinfectants, be sure to follow the manufacturer’s instructions. For disinfection,
Philips recommends the following:
• Discide Ultra Towelettes: Manufacture - Palmero, www.palmero-health.com (or equivalent)
4.8 CLEANING THE CARRYING CASE
If necessary, the carrying case can be washed in a washing machine using a mild laundry detergent. Air dry.
To wash the carrying case, use only warm water and a mild liquid dish detergent
1. Remove the SimplyGo/SimplyFlo device from the carrying case.
2. Dampen a cloth in the detergent and water solution and wipe the outside surfaces of the case
clean.
WARNING
To avoid electrical shock, do not remove the SimplyGo/SimplyFlo Covers. Do not apply liquid
directly to the covers. Do not use alcohol, solvents, polishes or any oily substances on the device,
as they are flammable.
CAUTION
Do not allow liquids into any of the controls, the interior of the case, or the oxygen tubing
connector.
To Next Page
Loading...
