PAGE 4-10
1097626, V
ER. 03
7. Press the Power button a second time to place the device in operating mode. This second press
helps prevent unwanted starts or inadvertent changes in oxygen flow. The Introductory screen
momentarily appears, shown at left below, followed by the final operating mode screen, shown at
right.
Every time it starts up, the device starts producing oxygen to meet the specified setting.It may
take up to twenty minutes to reach the specified purity levels for the setting.It is safe to begin
breathing from the SimplyFlo device immediately.
8. To set the device’s flow setting, press either the + or – button.
To increase the flow setting, press the + button.To decrease the flow setting, press the – button.
The device can be set to .5, 1, 1.5, and 2 liters per minute (LPM) of continuous flow.
9. Be sure oxygen is flowing through the cannula. If it is not, refer to the Troubleshooting section of
this manual.
10. Position the nasal cannula on your face, as shown below, and breathe normally through your
nose.
NOTE
When it is turned on, the device will automatically start at the flow rate setting used when the
device was last turned off. As a precaution, each time you start the device, verify the flow setting.
WARNING
It is very important to set your device to your prescribed level of oxygen flow.Do not increase or
decrease your flow rate from your prescribed level until you first consult with your health care
professional.
To Next Page
Loading...
