PAGE 4-91097626, VER. 03
5.
Connect a nasal cannula to the patient cannula connector on top of the device. Ensure that the cannula is
routed to prevent it from
being pinched or kinked to avoid a disruption of oxygen flow?
.
6. To start the device, press the Power button.After the first press, the display screen and the 4 but-
ton backlights turn on and you will see a screen similar to the one shown below.
NOTE
A standard single lumen nasal cannula and tubing (not supplied) should be used to deliver oxygen from
the device. The device works with cannula tubing up to 100ft. (30.5 m).
ITEM DESCRIPTION
1 Push Power again to turn
device on.
2 Total number of operating
hours for the device.
3 Software version in the
device.
4 Indicates the allowable
modes configuration of the
device. Note: This may not
display on all devices. This
is normal
To Next Page
Loading...
