PAGE 7-91097626, VER. 03
6. Remove the 7 screws securing the Spine Assembly to the Front Enclosure and remove the Front
Enclosure.
Installation: (for item identification, refer to removal instructions above)
1. Connect the Front Enclosure to the spine assembly by tightening the 7 screws to 6 in.-lbs.
2. Connect the Patient Outlet Tubing to the Patient Filter.
3. Connect the display ribbon cable to J18 on the Main PCA.
4. Connect the Power Harness to J2 on the Main PCA.
To Next Page
Loading...
