PAGE 7-351097626, VER. 03
Installation: (for item identification, refer to removal instructions above)
1. With the wire harness oriented towards the inlet filter and next to the Inlet Filer, align the four rub-
ber mounts with the four holes in the spine assembly.
2. Push the rubber mounts completely through the holes in the spine assembly to lock the fan
assembly in place. If the rubber mounts do not go through the holes grab the rubber mounts with
your finger and pull until it is completely through the hole.
3. Install the Compressor Cover.
4. Install the Sieve Canisters.
5. Install the Main PCA Assembly.
6. Install the Front Enclosure.
7. Install the Rear Enclosure.
To Next Page
Loading...
