Physio Control LIFEPAK 9 - Page 136

LIFEPAK 9 Shock Advisory Adapter
,
。
=
|
2
WARNING
|
Shock
or
fire
hazard.
Equipment
or
accessories
improperly
interconnected
to
each
other
can
be
a
source
of
ignition
or
have
a
shock
potential.
Make
sure
that
all
equipment
is
interconnected
safely
in
accordance
with
NFPA
(National
Fire
Protection
Association)
70-1990,
National
Electric
Code.
|
Note. Within certain governmental jurisdictions, all interconnected
accessory equipment must be labeled by an approved testing
laboratory. It is important that you verify and observe the required
applications in your location. Check leakage current and grounding
requirements after interconnecting this instrument with accessory
equipment.
Possible instrument damage. Sterilization environments can
cause severe damage to the instrument and accessories. Do not
autoclave or gas sterilize accessories unless manufacturer
instructions clearly approve it.
Possible instrument damage. Broken or frayed wires, or loose
snap fittings may cause interference or loss of signal. Pay
particular attention to the point at which the wires enter the
terminals. Repeated flexing at these points eventually causes the
wire strands to break. Perform frequent electrical and visual
inspections on cables and wires.
All Rights Reserved © November 1994 Physio-Control Corporation