Physio Control LIFEPAK 9 - PIP-Required Equipment

LIFEPAK 9 shock advisory adapter Service Manual
PIP-Required Performing this PIP requires the equipment listed in Table 3-1. Although
Equipment specific test instruments are recommended, other test equipment with
equivalent specifications may be used.
Table 3-1 PIP Test Equipment
Equipment Specifications Manufacturer
Defibrillation Cable Physio-Control PN 804089
ECG paper Box of three rolls Physio-Control PN 804700-000
LIFEPAK 9 defibrillator/monitor Calibrated Physio-Control PN 803800 or
or LIFEPAK 9P 805460
defibrillator/monitor/pacemaker
Patient Simulator Physio-Control PN 803499
Safety analyzer 110Vac Line Voltage: Dynatech Nevada 232HD or
current range 0-2000uA equivalent*
current accuracy +1%
resistance accuracy +1%
230Vac Line Voltage: Dynatech Nevada 432HD or
200uA/5% of reading equivalent*
2000uA/1% of reading
resistance accuracy +1%
*
Equivalent
equipment
is
required
to
meet
the
specifications
listed
in
the
specifications
column.
er
Eguipment
AI
test
eguipment
used
in
performing
the
PIP
must
have
a
current
entsaton
calibration
label
affixed
to
its
exterior.
The
calibration
label
must
be
issued
by a certified
calibration
facility.
PIP-Workstation
The
ac
line
power
for
this
workstation
must
be
connected
to
a
grounded
power
source.
PIP-Personnel
Personnel
performing
this
PIP
must
be
thoroughly
familiar
with
the
operation
of
the
LIFEPAK
9
defibrillator/monitor
and
the
Shock
Advisory
Adapter.
In
addition,
personnel
performing
this
PIP
must
meet
at
least
one
of
the
following
levels
of
education
or
experience:
e
Associate
of
applied
science
degree
with
a
major
emphasis
in
biomedical
electronics
e
Certificate
of
technical
training
in
electronics
with
a
major
emphasis
in biomedical
electronics
‧
Equivalent
biomedical
electronics
experience.
© November 1994 Physio-Control Corporation
3-2
All
Rights
Reserved