Physio Control LIFEPAK 9 - Cleaning Procedures; Table 1-2 Table; Exterior Cleaning; Tools and Materials for Cleaning and Repair

LIFEPAK 9 shock advisory adapter Service Manual
Tools and Materials for | Table 4-2 lists recommended tools, materials, and chemicals required for
Cleaning and Repair cleaning and repair. Although specific items are recommended in
Table 4-2, other tools and materials with specifications equivalent to
those listed may be used.
Table 4-2 Tools and Materials for Cleaning and Repair*
Product Description
Static-protected work area Grounded conductive surface and wrist strap
Crocus cloth
Isopropyl alcohol
Acid brush
Cotton swabs
Vacuum cleaner
Soft-bristle brush Nonmetallic
Cloth Clean and lint-free
Compressed air Clean and dry (60 psi, max.)
Electronic Supply Dealers
X-32B and Xersin® solder Low flux, no cleaning necessary
Multicore
Westbury, NY 11590
5-Minute® Epoxy Adhesive
Devcon
Danvers, MA 01923
Tak Pak® Adhesive and 710 accelerator
Loctite
Newington, CT 06111
Silverstat Low-static desoldering tool
Edsyn
Van Nuys, CA 91406
Soldapullt® Model AS196
=
This
symbol
CE:
Cleaning Procedures Clean the instrument as needed during maintenance or after disassembly
and repair.
Exterior Cleaning The Shock Advisory Adapter and its cables should be cleaned by wiping
the surface with any of the following solutions:
e Soap and water
e Quaternary ammonium compounds
4 一 4 All Rights Reserved © November 1994 Physio—Control Corporation