Physio Control LIFEPAK 9 - Functional Test and Calibration Procedures; Servicing Guidelines; TCP-Definitions; TCP-Requirements

Testing 3
Functional Test and
Calibration Procedures
© OCAUTION
Servicing Guidelines
TCP-Scope and
Applicability
TCP-Definitions
TCP-Requirements
TCP-Equipment
Requirements
© November 1994 Physio-Control Corporation
Perform the applicable tests in this section if the instrument fails a test in
the PIP or if there is a suspected failure in an assembly. Each test may be
performed separately from the other tests. Always perform the PIP after
completing any tests in this section.
Test and calibration, repair, and component removal should be attempted
only by personnel qualified by training or experience. Printed circuit
boards (PCBs) which cannot be repaired in the field should be returned to
Physio-Control for service.
Shock hazard. Do not touch exposed terminals and wires while
instrument power is on.
Avoid component damage. Static Sensitive Devices (SSDs).
Use the Special Handling Procedures for Static Sensitive Devices
described in section 4 to prevent build up of static charge. Refer to
Table 5-1 to identify PCB assemblies containing SSDs.
Some test and calibration procedures may require opening the instrument
case. Disassembly procedures are provided in Section 4.
Perform a close visual inspection before disassembly.
Label each lead or draw a sketch showing the location of cables and
wires before removing a PCB or mechanical assembly for repair or
replacement.
This
TCP
applies
to
all
configurations
of
the
Shock
Advisory
Adapter.
This
PIP
does
not
apply
to
the
LIFEPAK
9
family
of
defibrillator/monitor/pacemakers;
refer
to
their
respective
service
manuals
for
testing
information.
Pushbuttons are indicated in CAPITAL LETTERS,
Displayed
messages
are
indicated
in
BOLD
CAPITAL
LETTERS.
The following are minimum requirements:
Instruments
necessary
for
testing
of the
LIFEPAK
9
shock
advisory
adapter
are
listed
in
Table
3-2.
Although
specific,
commercially
available
test
instruments
are
recommended,
other
test
equipment
with
specifications
equivalent
to
those
listed
may
be
used.
All Rights Reserved 3-9