Physio Control LIFEPAK 9 - Page 138

LIFEPAK 9 Shock Advisory Adapter
General Information
Service Before attempting to clean or repair any assembly in this instrument, the
Information technician should be familiar with the information provided in Section 4,
Service and Maintenance.
A gualified technician should check a product that has been dropped,
damaged, or severely abused to verify the instrument is operating within
performance standards as listed in Section 3, Performance Inspection
Procedure (PIP), and that the leakage current values are acceptable. -
If calibration or more extensive testing is required, a qualified technician
can perform the Test and Calibration Procedure (TCP), also in
Section 3. Component replacement and internal adjustments must be
performed only by personnel qualified by appropriate training and
experience.
The use of defibrillation electrodes and adapter devices from sources
other than Physio-Control is not recommended. Physio-Control has no
information regarding performace of electrodes and adapter devices from
other sources. If instrument failure is attributed to electrodes or adapters
not manufactured by Physio-Control, the warranty may be voided.
Component replacement and internal adjustments must be made by
service personnel qualified by appropriate training and experience.
If assistance in servicing the instrument is needed in the USA, contact
Physio-Control at 1-800-442-1142. Outside the USA, contact your local
Physio-Control service or sales representative.
xii
All
Rights
Reserved
©
November
1994
Physio-Control
Corporation