Physio Control LIFEPAK 9 - Page 170

LIFEPAK 9 shock advisory adapter Service Manual
4-6
Prevent nameplate damage. Do not use abrasive cleaners or \
solvents to wipe nameplates and labels—the nameplate information
may disappear.
. Wipe surfaces of nameplates and labels with a clean, dry cloth.
Avoid equipment damage. Do not use solvents to clean
plastic parts.
. Clean surfaces of plastic parts with a mild soap and water solution.
Dry with a clean cloth.
. Clean soldering surfaces with a nonmetallic, soft-bristle brush dipped
in alcohol then wipe with absorbent cloth. Air dry 10 minutes or use
low-pressure compressed air (60 psi) before soldering.
All
Rights
Reserved
©
November
1994
Physio-Control
Corporation