Physio Control LIFEPAK 9 - Page 91

LIFEPAK 9 defibrillator/monitor
2. Reconnect the battery to the defibrillator/monitor.
Note: The Power Supply compensates for temperature fluctuations. The
defibrillator/monitor must be powered—on for at least 30 minutes
prior to calibration so the temperature around thermistor RT2
stabilizes.
3. Connect the DMM between the positive and negative battery terminals.
4. Connect the ac power cord and press ON.
5. Locate R23. Remove the potting compound from R23 as required to
allow adjustment. Adjust R23 for +18.40 +0.18V.
TCP-Recorder 1. Remove the front panel. The two potentiometers (R176 and R8 on the
Calibration Main PCB) required for Recorder Calibration are accessible with the
front panel removed as shown in Figure 3-13.
Мам РСВ — 、
Motor Speed Adjust R8
Paper Out Sense R176
CRT
(FRONT PANEL REMOVED)
Figure 3-13 Recorder Calibration Adjustments Location
170008-001 Orig
3-34 All Rights Reserved © August 1993 Physio—Control