PI MS249E - Page 233

8 GCS Commands
C-863.12 Mercury Controller MS249E Version: 1.2.1 227
-1083
PI_WRONG_DATA_TYPE
A function argument has an
unexpected data type.
-1084
PI_DIFFERENT_ARRAY_SIZES
Length of data arrays is
different.
-1085
PI_PARAM_NOT_FOUND_IN_PARAM_DAT
_FILE
Parameter value not found in
parameter DAT file.
-1086
PI_MACRO_RECORDING_NOT_ALLOWED_I
N_THIS_MODE
Macro recording is not
allowed in this mode of
operation.
-1087
PI_USER_CANCELLED_COMMAND
Command cancelled by user
input.
-1088
PI_TOO_FEW_GCS_DATA
Controller sent too few GCS
data sets
-1089
PI_TOO_MANY_GCS_DATA
Controller sent too many GCS
data sets
-1090
PI_GCS_DATA_READ_ERROR
Communication error while
reading GCS data
-1091
PI_WRONG_NUMBER_OF_INPUT_ARGUM
ENTS
Wrong number of input
arguments.
-1092
PI_FAILED_TO_CHANGE_CCL_LEVEL
Change of command level has
failed.
-1093
PI_FAILED_TO_SWITCH_OFF_SERVO
Servo mode has failed to
switch off.
-1094
PI_FAILED_TO_SET_SINGLE_PARAMETER_
WHILE_PERFORMING_CST
A parameter could not be set
while performing CST: CST
was not performed
(parameters remain
unchanged).
-1095
PI_ERROR_CONTROLLER_REBOOT
Connection could not be
reestablished after reboot.
-1096
PI_ERROR_AT_QHPA
Sending HPA? or receiving the
response has failed.
-1097
PI_QHPA_NONCOMPLIANT_WITH_GCS
HPA? response does not
comply with GCS2 syntax.
-1098
PI_FAILED_TO_READ_QSPA
Response to SPA? could not
be received. Response to
SPA? could not be received.
-1099
PI_PAM_FILE_WRONG_VERSION
Version of PAM file cannot be
handled (too old or too new)
-1100
PI_PAM_FILE_INVALID_FORMAT
PAM file does not contain
required data in PAM-file
format
-1101
PI_INCOMPLETE_INFORMATION
Information does not contain
all required data