PIAGGIO Beverly 400 E5 - Page 157

4. Drive at a low speed for a few meters, until the
"ABS" indicator light stops flashing.
5. To start the programming procedure, press the
start button and the ASR button at the same time
for at least 4 seconds, until the "ASR OFF" icon
starts flashing; then release the buttons.
6. Start driving and increase the speed up to 30
km/h within 1 minute, keep the speed constant
for at least 10 seconds,
The "ASR OFF" icon switched off indicates that
the calibration was successful.
7. Stop the vehicle and shut off the engine by
turning the starter switch to the "OFF" position.
8. If the procedure has been completed cor-
rectly, the next time the starter switch is turned
to the "ON" position, the "ASR" icon lights up
with 1Hz slow flashing (1 flash per second).
When starting the engine, the "ASR" icon turns off
and the ASR system will be ACTIVE.
9. If the procedure is NOT completed correctly,
the "ASR OFF" icon will be switched on steady.
By pressing the appropriate button, the user can
manually reactivate the ASR system by returning
it to the previously stored calibration.
WARNING
N.B.
BY TURNING THE STARTER SWITCH TO THE "ON" POSITION, THE FLASHING ASR ICON IN-
DICATES THE SYSTEM DIAGNOSIS PHASE. IF THERE IS NO FLASHING WHEN THE ENGINE IS
STARTED, THE ASR SYSTEM MAY NOT BE WORKING.
WARNING
Beverly 400 E5 Braking system
BRAK SYS - 157