PIAGGIO Runner 125 - Helmet bay

Helmet bay
- Remove the battery after disconnecting the wir-
ing.
- Remove the saddle.
- Remove the rear central cover.
- Remove the side panels
- Remove the wiring found in the battery compart-
ment.
-Disconnect the cable of the saddle opening de-
vice.
- Remove the 5 screws indicated in the figure lo-
cated on the front part of the helmet compartment.
- Remove the 2 screws indicated in the figure lo-
cated on the rear part of the helmet compartment.
- Remove the screw indicated in the figure located
on the rear wheel compartment, and then remove
the helmet compartment.
See also
Side fairings
Seat
Chassis Runner 125 - 200
CHAS - 278