PIETRO FIORENTINI FE Series User Manual

54
SERIES FE
EN
LOW-PRESSURE GAS REGULATOR | INSTALLATION | REV. 00
Use, maintenance and warning manual
To install the equipment, proceed as specied in Tab. 6.33.:
Step Action
1 Apply the checks in paragraph 6.1.3 (“Checks before installation”).
2 Remove any type of packaging/equipment protection (if any).
3
Connect making sure that:
• the inlet and outlet pipes do not exert excessive bending or traction forces on the regulator body as a result
of not being aligned. If necessary, clamp the inlet/outlet pipes for proper alignment;
• the connections and/or terminals of the inlet and outlet pipes are suitable for and compatible with the
ttings on the regulator.
NOTE!
• If there are swivel connectors, use the gaskets supplied by PIETRO FIORENTINI S.p.A.
• In case of direct assembly in the regulator body, use only cylindrical GAS connections (ref.
UNI EN ISO 228-1).
Tab. 6.33.
NOTE!
The warranty shall be deemed null and void and PIETRO FIORENTINI S.p.A. shall not be held liable for any
damage and/or malfunctions if the ttings used during installation are not those supplied.
6.4.1 - POST-INSTALLATION INSTRUCTIONS
WARNING!
Make sure all connections are properly tightened to prevent any leakage during commissioning.
WARNING!
Protect the regulator from blows and impacts, even accidental.

PIETRO FIORENTINI FE Series Specifications

General

Brand	PIETRO FIORENTINI
Model	FE Series
Category	Controller
Language	English