9
SERIES FE
LOW-PRESSURE GAS REGULATOR | GENERAL INFORMATION | REV. 00
EN
Use, maintenance and warning manual
2 - GENERAL INFORMATION
2.1 - MANUFACTURER IDENTIFICATION
Manufacturer PIETRO FIORENTINI S.P.A.
Address
Via Enrico Fermi, 8/10
36057 Arcugnano (VI) - ITALY
Tel. +39 0444 968511 Fax +39 0444 960468
www.orentini.com sales@orentini.com
Tab. 2.2.
2.2 - IDENTIFICATION OF THE PRODUCT
FE LOW-PRESSURE GAS REGULATOR
Series Equipment
Available models
• FE6
• FE10
• FE25
• FES
Tab. 2.3.
2.3 - REGULATORY FRAMEWORK
PIETRO FIORENTINI S.P.A. with registered ofces in Arcugnano (Italy) - Via E. Fermi, 8/10, declares that the equipment of
SERIES FE described in this manual is designed, manufactured, tested and checked in compliance with the requirements
of standards: UNI 11655:2016, UNI EN 16129:2013 where applicable.
NOTE!
For specic type approvals, see the appropriate section on the Manufacturer’s website: https://www.or-
entini.com
NOTE!
The declaration of conformity in its original version is delivered together with the equipment and this man-
ual.
2.4 - WARRANTY
PIETRO FIORENTINI S.P.A. guarantees that the equipment was manufactured using the best materials, with high quality
workmanship, and complies with the quality requirements, specications and performance set out in the order.
The warranty shall be considered null and void and PIETRO FIORENTINI S.P.A. shall not be liable for any damage and/or
malfunctions:
• due to any acts or omissions of the purchaser or end-user, or any of their carriers, employees, agents, or any third
party or entity;
• in the event that the purchaser, or a third party, makes changes to the equipment supplied by PIETRO FIORENTINI S.P.A.
without the prior written approval of the latter;
• in the event of failure by the purchaser to comply with the instructions contained in this manual, as provided by
PIETRO FIORENTINI S.P.A.
NOTE!
The warranty conditions are specied in the commercial contract.
To Next Page
Loading...
Need help?
General
