70
SERIES FE
EN
LOW-PRESSURE GAS REGULATOR | UNINSTALLATION AND DISPOSAL | REV. 00
Use, maintenance and warning manual
9.4 - INFORMATION REQUIRED IN CASE OF NEW INSTALLATION
NOTE!
Should the equipment be reused after uninstallation, refer to chapters: “Installation” and “Commission-
ing”.
9.5 - DISPOSAL INFORMATION
NOTE!
• Proper disposal prevents damage to humans and the environment and promotes the reuse of precious
raw materials.
• Bear in mind that the regulations in force in the country of installation must be complied with.
• Illegal or improper disposal involves the application of the penalties provided for by the regulations in
force in the country of installation.
The equipment was manufactured with materials that can be recycled by specialised companies.
For proper disposal of the equipment, proceed as specied in Tab. 9.47.:
Step Action
1 Set up a large work area free from obstacles where to safely dismantle the equipment.
2 Sort the various components by type of material for easier recycling through separate collection.
3 Send the materials obtained in Step 2 to a specialised company.
Tab. 9.47.
The equipment in any conguration consists of the following materials:
Material Present in Disposal/recycling indications
Nitrile rubber
(TR rubberised canvas)
• Diaphragm
• O-rings
It must be dismantled and disposed of separately.
Plastic
• Caps
• Discs
It must be dismantled and disposed of separately.
Steel • Springs
Disassemble and collect separately.
It must be recycled through the specic collection
centres.
Zamak metal alloy
• Equipment body
• Lids
• Seat
Disassemble and collect separately.
It must be recycled through the specic collection
centres.
Aluminium alloy
(on request)
• Equipment body
• Lids
Disassemble and collect separately.
It must be recycled through the specic collection
centres.
Tab. 9.48.
NOTE!
The above materials refer to standard versions. Different materials can be provided for specic needs.
To Next Page
Loading...
Need help?
General
