Safety
Operating Manual PNOZ m C0
1006013-EN-02
| 10
3 Safety
3.1 Intended use
The standalone base unit PNOZ m C0 is used for the safety-related interruption of safety
circuits and is designed for use in:
} Emergency stop equipment
} Safety circuits in accordance with VDE0113 Part 1 and EN60204-1
CAUTION!
Inputs and outputs for standard functions must not be used for safety-re-
lated applications.
Lifts Directive
The product PNOZ m C0 can be used as a PESSRAL (programmable electronic system in
safety-related applications for lifts) in accordance with the Lifts Directive 2014/33/EU. It
meets the requirements for passenger and goods lifts in accordance with EN 81-1/2, EN
81-20, EN 81-22 and EN 81-50, as well as the requirements for escalators and moving
walks in accordance with EN 115-1.
The safety controller should be installed in a protected environment that meets at least the
requirements of pollution degree 2.
Example: Protected inside space or control cabinet with protection type IP54 and appropri-
ate air conditioning.
Year of manufacture
The year of manufacture is specified on the product after the reference YOM (Year of Man-
ufacturing).
Improper use
The following is deemed improper use in particular
} Any component, technical or electrical modification to the product,
} Use of the product outside the areas described in this operating manual,
} Use of the product outside the technical details (see Technical details [ 30]).
NOTICE
EMC-compliant electrical installation
The product is designed for use in an industrial environment. The product
may cause interference if installed in other environments. If installed in other
environments, measures should be taken to comply with the applicable
standards and directives for the respective installation site with regard to in-
terference.
To Next Page
Loading...
Need help?
General
