Pilz PRBT 6 - Page 9

Overview
System Description Service Robotics Modules
1004870-EN-05
| 9
} Communication interface (Ethernet) for transmitting the robot program from the
teach pendant to the motion controller
[3] Robot control module PRCM1
Control cabinet with
} Safety control system from Pilz including
– Pre-installed PSS4000 user program
– Digital FS and ST inputs
– Digital FS outputs
} Motion controller from Pilz including
– Pre-installed motion control user program
– Communication interface (CANopen) for controlling the axes and the end-ef-
fector
– Communication interface (Ethernet) for transmitting the robot program from
the teach pendant to the motion controller
} Low voltage power supply (24 V DC)
} Control cabinet main switch
[4] Connection cable to X3 (AUX) of the robot arm with
Lines for control of an end-effector
[5] Connection cable to X2 (signals) of the robot arm with
} STO lines from the safety control system to the robot arm
} CANopen lines from the motion controller to the robot arm
[6] Connection cable to X1 (power) of the robot arm with
Voltage supply lines for supplying the robot arm and an end-effector with 24V DC
[7] Connection cable to the teach pendant with
} Lines to the safety control system and to the motion controller
} Voltage supply lines for supplying the teach pendant with 24V DC