Pioneer PDP-433CMX - Page 184

184
RS-232C Adjustment Mode
3) <GSS> (GET STATUS SET UP) Set data for SET UP will be output as follows.
Order Data Size Output Remarks
1 COLOR TEMP 1byte 1: COLOR TEMP1
2: COLOR TEMP2
3: COLOR TEMP3
4: COLOR TEMP4
5: COLOR TEMP5 (NOTE)
2 DIGITAL NR 1byte 0: OFF
1: LOW
2: MIDDLE
3: HIGH (NOTE)
3 HIGH CONTRAST 1byte 0: OFF, 1: ON
4 PURECINEMA 3byte Same as RS-232C command (NOTE)
5 COLOR SYSTEM 3byte Same as RS-232C command (NOTE)
6 CLAMP POSITION 1byte 1: AUTO
2: LOCKED (NOTE)
7 3D Y/C MODE 1byte M: MOTION
S: STILL (NOTE)
8 SETTING/VIDEO SIGNAL 3byte Same as RS-232C command (NOTE)
9 2 X 2MODE 1byte 0: OFF
1 to 4: MG to MG4
10 BRIGHT ENHANCE 1byte 0: OFF, 1: ON
11 HDTV MODE 3byte Same as RS-232C command (NOTE)
12 VIDEO INPUT 1byte 1: COMPONENT1
2: COMPONENT2 (NOTE)
13 Input functions 3byte IN∗
14 Screen size 1byte 0: DOT BY DOT
1: 4:3
2: FULL
3: ZOOM/PARTIAL
5: WIDE
15 SUB VOLUME (INPUT1) 2byte 0 to 60
16 SUB VOLUME (INPUT2) 2byte 0 to 60
17 SUB VOLUME (INPUT3) 2byte 0 to 60 (NOTE)
18 SUB VOLUME (INPUT4) 2byte 0 to 60 (NOTE)
19 SUB VOLUME (INPUT5) 2byte 0 to 60 (NOTE)
(NOTE) For set data unrelated to the current input function, input signal and settings, dummy data will be output.