PLANET ECLIPSE LV1.6 - Velocity Adjustment

FIG-1
1
B
1/8
A
-
+
15
INTRODUCTION
VELOCITY ADJUSTMENT
FIG-1
The LV1.6 velocity adjustment screw is accessed from the bottom of
the foregrip.
Insert a 1/8 hex key
A
into the velocity adjuster screw
B
to adjust
the velocity.
1
Turn the hex key clockwise to reduce velocity.
2
Turn the hex key counter-clockwise to increase velocity.
3
Fire two clearing shots after each velocity adjustment for an
accurate velocity reading.
1
DO NOT turn the adjustment screw in too far. This will prevent
the marker from ring.
WARNING!
DO NOT exceed 300FPS.
Always wear correct protective equipment when ring your marker.
NEVER leave the marker gassed up when unloading.
NEVER point your marker in the direction of other people when not on the eld.
WARNING