FIG-1
FIG-3
FIG-2
FIG-4
36
ELECTRONICS
USER INTERFACE PARAMETERS
FIG-1 - TRAINING PARAMETER
This simulates the ring cycle (in unloaded state)
using a BEEP to simulate a shot red, allowing the
user to practice their trigger technique o the eld
without ring the marker.
> ON: Training mode enabled.
> OFF: Training mode disabled.
FIG-2 - SHOT COUNT MENU
This menu contains items associated with the
shot counter.
FIG-3 - GAUGE PARAMETER
This toggles the visibility of the shot counter gauge
graphic on the run screen.
> ON: Gauge graphic enabled.
> OFF: Gauge graphic disabled.
FIG-4 - GAUGE MAX PARAMETER
Sets the number that the gauge counts down
from every time the marker is red.
This parameter can be set between 100 and
2000 in increments of 10.
To Next Page
Loading...
