PLANET ECLIPSE LV1.6 - Page 45

45
FAULT FINDING
FAULT FINDING TABLES
SYMPTOM POSSIBLE CAUSE SOLUTION
Low rate of re/rate of re not reaching the
ROF cap.
Rear solenoid ow restrictor is set too low. Set the rear SFR to its factory level.
The force setting of the loader is too low. Adjust the loader force feed settings.
The marker is chopping or trapping paint.
The paint is poor quality. Try a higher quality of paint.
The BS is switched off. Switch on the BS.
The bolt is dirty causing the BS to incorrectly detect a
paintball.
Clean the bolt and breech.
The BS is dirty causing the incorrect detection of
paintballs.
Clean the BS.
Incorrectly seated rubber bolt tip. Replace the rubber bolt tip.
Damaged rubber bolt tip. Replace the rubber bolt tip.
Low constant velocity.
The regulator output pressure is set too low. Increase the output pressure.
The LPR is set too low. Increase the output pressure of the LPR.
The solenoid ow restrictor (SFR) B is set too low. Set SFR B to level 6-7.
The cam-lever is incorrevtly installed. Strip down and re-install the cam lever assembly correctly.
Low velocity rst shot.
The FSD comp parameter is too low to overcome
stiction on solenoid and/or rammer o-rings.
Increase FSD comp parameter.
High velocity rst shot.
The FSD comp parameter is set too high. Reduce FSD comp parameter.
The inline regulator pressure is creeping. Strip and clean inline regulator replacing piston seal if necessary.
The LPR pressure is creeping. Strip and clean the LPR replacing piston seal if necessary.
The trigger is very 'bouncy'.
Incorrect lter settings. Check trigger lter and debounce settings suit your trigger setup.
Trigger pull is too short and return strength is too low. Return the trigger operation to standard, then adjust.