User Manual of WAP-200N/WBS-200N
-13-
Firewall
Offers DoS protection to guard user's content network against DoS attacks
Built-in DMZ and Port Forwarding
VPN Pass-through:
PPTP Pass-through
L2TP Pass-through
IPSec Pass-through
Channel Width
20MHz/40MHz
Encryption Type
64-/128-/152-bit WEP, WPA, WPA-PSK, WPA2, WPA2-PSK, 802.1X
Wireless Security
Enable/Disable SSID Broadcast
Wireless MAC address filtering up to 50 entries
VAP Separation, Station Separation
Max. Wireless Clients
Max. 64 (Suggested 32, depending on usage)
Max. SSIDs
Up to 4
Max. WDS Peers
Up to 4
Wireless QoS
Supports Wi-Fi Multimedia (WMM)
Supports Wireless Traffic Shaping per Radio
Wireless Advanced
Control
Auto Channel Selection
Auto Transmit Power by Regular Domains
Client Limit Control
Distance Control (Auto Ack Timeout)
Wi-Fi Schedule
Status Monitoring
Connection Status
Device Discovery, PLANET Smart Discovery
Wireless Client List/WDS Link List
DHCP Client Table
System Log supports remote syslog server
Signal Strength LEDs in Client Bridge and WDS Station modes
VLAN
VLAN pass-through over WDS
SSID-to-VLAN mapping
Management VLAN (VID: 1~4094)
Self-healing
Supports auto reboot settings
NTP
Network Time Management
Management
Web-based UI, CLI (Command Line Interface) supported
Configuration backup and restore
SNMP v1/v2c/v3 support, MIB I/II, Private MIB
Diagnostic Tools
Built-in Ping, Trace Route, Speed Test Tools
To Next Page
