Planet WAP-200N - Figure 5-8 Operation Mode - Repeater; Repeater

User Manual of WAP-200N/WBS-200N
-45-
5.1.7 Repeater
This section allows you to configure the Repeater mode to extend the root AP’s signal coverage.
Go to the “System  Operation Mode” page to configure the device as “Repeater” and then go to “Wireless 
Wireless Network” to configure the related wireless settings.
Figure 5-8 Operation Mode – Repeater
Configuration Example
The following procedure will guide you to how to establish repeater connection.
Step 1. Go to “Operation Mode” page to configure the device as “Repeater”.