8. Press softkey [ ] to send the Group call.
•“Transmitting Group Call” is displayed, and then the assigned channel is automatically selected.
NOTE: If Channel 70 is busy, the transceiver stands by until the channel becomes clear.
9. Hold down [PTT] to communicate.
◆Receiving a Group Call
When a Group call is received:
•The alarm sounds for 2 minutes.
•”RCVD GROUP CALL” is displayed.
1. Press softkey [ ] to turn OFF the alarm.
•The channel that is assigned by the caller is automatically selected after 10 seconds by default.
2. Press the softkey for the next operation.
Press [ ]: Ingores the call and returns to the operating screen.
•” ” blinks continuously until you display the call message.
•The call is saved in the DSC Log.
Press [ ]: Pauses the countdown until the assigned channel is automatically selected.
NOTE: is not displayed if the “CH Auto SW” item is set to “Manual”.
•Select[ ] to resume the countdown.
•The call is saved in the DSC Log.
Press [ ]: Accepts the call.
•The assigned channel is automatically selected.
•The call is saved in the DSC Log.
Press [ ]: Closes the Group call, then returns to the operating screen.
Press [ ]: The receiver call’s information is displayed.
To Next Page
Loading...
