11
*) If it is not possible to locate the unit in a place that fully complies with the above requirements, make sure
that the following points are obeyed:
• if the room temperature is higher than recommended, monitor the temperature in the chamber using
an additional independent temperature sensor.
• if the room temperature is lower than recommended, under no circumstances should you turn the
cooling system on, as this may damage the compressor; At room temperatures between 0° to 10°C
it is only possible to heat up the chambers (only for: CHL, ST, IL).
• in highly humid environments, control the frosting of evaporator and walls more often than recom-
mended. If necessary, perform the defrosting operation (only for: CHL, ST, IL).
The waste water is discharged by gravity. The drain hose cannot be higher at any point than the drain outlet,
otherwise, this may cause leakage from the bottom of chamber and may damage the humidifier.
If you don’t comply with the recommendations of place of installation, you may lose your warranty rights.
If you don’t comply with the above recommendations, it may deteriorate the following technical parameters:
• temperature stability
• temperature homogeneity
• power consumption
• frosting of evaporator
Non-compliance with the above recommendations may result in damage to the unit or impair technical param-
eters.
The electric installation should meet the following conditions:
The electric installation should be secured by a 16A antisurge fuse.It is recommended that the installation is
equipped with a residual current circuit breaker.
To Next Page
Loading...
Need help?
General