POL-EKO-APARATURA sp.j. • ul. Kokoszycka 172 C • 44-300 Wodzisław Śl. • tel./fax +48 32 453 91 70 • e-mail info@pol-eko.com.pl
65
9.2. Interior cleaning
The chamber should be emptied of any samples before cleaning.
Open the door of the device and wait for the frost to melt, take out the shelves and start cleaning the
device.
Only water or mild detergent should be used.
Having finished cleaning, you should allow the device to dry fully and fit all parts removed before clean-
ing.
During cleaning pay attention not to damage the temperature sensor in the chamber.
In drying oven (SL) could happened the internal bottom metal part becomes discolored. It is caused be
very high heaters temperature which are placed just under bottom metal part. Change of color of the
sheet does not cause any malfunction.
10. ADVICE ON HOW TO SAFELY STORE THE DEVICE
Remove all objects from the chamber.
Disconnect the device from the mains.
Clean and dry the chamber.
Leave the door open to allow adequate ventilation.
Store in temperatures between 0°C and 50°C and relative humidity maximum 70%.
11. TROUBLESHOOTING
Before you contact POL-EKO Aparatura Service Department:
Make sure that the operation complies with the instruction manual of the device.
Restart the device to make sure that the unit is not functioning properly. If it still does not work,
disconnect the unit again from the mains and repeat the operation after one hour.
To Next Page
Loading...
Need help?
General