POL-EKO SMART User Manual

Instruction Manual SMART
POL-EKO-APARATURA sp.j. • ul. Kokoszycka 172 C • 44-300 Wodzisław Śl. • tel./fax +48 32 453 91 70 • e-mail info@pol-eko.com.pl
66
11.1. Possible defects
Malfunction
What to check
What to do
The unit is not working
Check the voltage in the socket
Measure the voltage in the
socket; if necessary, change
the fuses in the electric installa-
tion in the building
Check if the unit is plugged in
Plug in the unit
Check the status of a circuit-breaker on the back
of the device
Press the circuit breaker on the
back of the device.
Check if the power cable is broken
Change the cable
The unit is not cooling
down
Check if the unit is exposed to direct sunlight
Change the location of the unit
Check if the unit is located near a radiator
Change the location of the unit
Check if the door of the unit is closed properly
Clean the gasket
Does the installation site meet the installation
conditions?
Adapt to the installation re-
quirements on site (according
to point 3)
The unit is not heating
up
Check if the door of the unit is closed properly
Clean the gasket
Check if the fan is turned on
If not please contact service
Does the installation site meet the installation
conditions?
Adapt to the installation re-
quirements on site (according
to point 3)
The unit is working too
loudly
Check if the unit is not touching other objects
(e.g. furniture etc.)
Remove other objects
Sagging or tilted doors
Check if the doors are properly leveled. (see
chapter 3).
If the doors are correctly lev-
eled and still are sagging,
please contact service.

POL-EKO SMART Specifications

General

Brand	POL-EKO
Model	SMART
Category	Controller
Language	English