Polaris 2014 Sportsman 570 EPS Forest - Page 301

7
7.19
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
© Copyright 2013 Polaris Sales Inc.
Installation
1. Install new compression ring on drive shaft. Apply an
anti-seize compound to splines. Align splines of drive
shaft with front gearcase and install by lightly tapping
on drive shaft with soft-faced hammer.
2. Install drive shaft in strut.
3. Install lower ball joint, torque nut to specification and
install new cotter pin.
Ball Joint Retaining Nut:
30 ft-lbs (41 Nm)
4. Install hub and tighten hub nut to specification.
Front Hub Retaining Nut:
60 ft-lbs (91 Nm)
5. Install brake caliper and tighten bolts to specification.
Refer to Chapter 9.
Brake Caliper Fastener:
18 ft-lbs (24 Nm)
6. Install wheel and tight wheel nuts to specification.
Refer to the beginning of this chapter.
FINAL DRIVE