7.24
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
© Copyright 2013 Polaris Sales Inc.
REAR DRIVE (CV) SHAFT
Inspection
Check the front and rear driveshaft CV boots for any
tears or leaking grease. If the driveshaft boot loses all
grease, CV joint failure will occur.
Removal
1. Remove rear hub. Refer to “REAR HUB REMOVAL”
in this chapter.
2. Remove upper carrier bolt. Tip hub outward and
remove shaft from carrier.
3. Pull sharply outward to remove shaft from
transmission. Install a new compression ring and
apply an anti-sieze compound to the splines upon
assembly.
Installation
1. Apply anti-seize compound to splines of shaft.
2. Install a new lock ring and install the inner shaft.
3. Slide shaft assembly into the bearing carrier hub.
4. Lift bearing carrier into place and install bolt to upper
control arm. Torque bolt to specification.
Upper Hub Carrier Bolt:
37 ft-lbs (50 Nm)
FINAL DRIVE
To Next Page
Loading...
